Beside this, why does my pool pump lose its prime?
Debris blocking the suction strainer or foot valve is the most common cause. A blockage in the intake line can cause the water in the pump casing to overheat and literally boil out of the casing causing the pump to lose prime.
Considering this, what does priming alarm mean Pentair?
Priming Failure
If the pump is not defined as primed within the “Max Priming Duration” it will stop and generate a “Priming Alarm” for 10 minutes, then attempt to prime again.
Why does pool pump not prime?
How do I prime my pool pump?
Steps to Prime Your Pool Pump
- Turn off the pump. …
- Switch to recirculate. …
- Release air. …
- Clean out the pump basket. …
- Fill the pump basket. …
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.
How do I start my Pentair pool pump?
How do I get an air bubble out of my pool pump?
How much water do you need to prime a pool pump?
Step 3: Fill Your Pump with Water
Once the basket is about 80% full—up to the outlet called the intake port—you’ll know the system is air free.
How long does it take to prime a Pentair pool pump?
When a steady stream of water comes out of the filter air relief valve, close the valve. 12. The pump will prime for 5 minutes. Note: Do not allow the pump to run longer than 30 minutes before succesfully priming.
How do you bleed air out of pool lines?
The trick to bleeding the pool lines of air is to start with all the line valves closed. With the pump running, very slowly open the valves to introduce air into the pump until the pump sucks out all the air.