Ideally, you need to run your robot pool cleaner daily or at least once a day if you’re always swimming in it. But if you don’t swim in it as much, run it at least once weekly or every two weeks. When you’re using a swimming pool cover all the time, you may wash your pool monthly.
Besides, can I leave my robotic pool cleaner in the pool?
You may only need to run the cycle two to three times a week. Leaving the machine in the water during that time exposes it to the elements unnecessarily. This exposure could cause the seals to deteriorate faster, allowing for leaks and damage to the electronic components.
Beside this, where is the impeller on my dolphin pool cleaner?
Why is my dolphin pool cleaner not climbing walls?
My Dolphin Won’t Climb Walls / Gets Stuck
Clean filters: The Dolphin’s filters may be clogged and need to be cleaned. Make sure you clean these filters after each use. Do not allow filters to dry out before cleaning. Deeper cleaning of the filters is also highly encouraged and may be required occasionally.
Can I leave my Dolphin pool cleaner in the pool overnight?
Can you leave the Dolphin in the water? It is safe to leave your Dolphin cleaner in the water when not in use. However, (when adding chemicals to the pool) please remove the Dolphin until the proper chlorine and PH balance are obtained.
How do I stop my pool cleaner from climbing walls?
How do I reset my dolphin?
Press and hold “Blue” and “Call” buttons to cold boot the Dolphin. Upon cold boot, when the display returns, type: 1277. A little menu will appear showing the reset options.
How often should a pool be vacuumed?
In general, it’s a good idea to vacuum your pool once a week. You should also vacuum your swimming pool any time you notice large amounts of debris, dirt, or leaves on the floor of the pool (for example, your pool may need vacuuming after a heavy storm).
How do you troubleshoot a Dolphin pool cleaner?
Troubleshooting
- Check that the power supply cable is plugged properly into the power supply socket. Check power to the socket and reconnect Pool Cleaner.
- Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box.
- Turn the power supply off. …
- Unplug the power supply.
Why is my pool cleaner going in circles?
Your pool robot is going in circles because its feet are unevenly worn, the hoses are tangled, the swivels are jammed, or there’s a broken belt. These issues cause the pool cleaner to lean to one side, making it rotate without moving straight. Check the feet and ensure they’re wearing evenly.