How do I reset my Intelliflo pool pump?

by

>> Click to read more <<

Beside above, how do I restart my pool pump?

Steps to Prime Your Pool Pump

  1. Turn off the pump. …
  2. Switch to recirculate. …
  3. Release air. …
  4. Clean out the pump basket. …
  5. Fill the pump basket. …
  6. Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
  7. Check the water flow to your pump.
Then, what do you do when the power goes out and your pool freezes? If the power goes out and your pool system stops running:

Cut off the current to your equipment from the circuit breaker. If your air bleed valve is frozen, open it up by melting the ice with warm water. Remove all drain plugs and drain the water from the pump and heater and store them inside the pump basket.

Furthermore, how do I reset my Pentair IntelliConnect?

Power down the IntelliConnect for ten (10) seconds to reset access point mode and proceed to Step 14 for recommendations on improving the signal/connection strength.

How do I reset my Pentair Intelliflo pump after a power outage?

Close any drain plugs or valves you may have opened during the power outage. Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on. Ensure your pool pump and filter are working, and then let them run for one hour to begin decontamination.

7 Related Question Answers Found

How do you unlock Pentair Intelliflo?

Press and hold all of the four Speed buttons simultaneously for four (or more) seconds. Power off the pump, wait a few seconds, power it back on.

How do I set the Pendair Intelliflo egg timer?

How do I reset my Pentair variable speed pool pump?

TO PERFORM A FACTORY RESET:

Press Start/Stop to stop the pump. 2. Record all of the custom schedule settings and the priming speed in Table 3. These settings can be found by pressing the “1”, “2”, “3”, and “Quick Clean” buttons and cycling through all the screens.

How do I reset my Pentair pool timer?

How to Set the Date/Time on the Pentair Intelliflo

  1. From the home screen, press the “Menu” button.
  2. Use the Up or Down Arrows to cycle to “Settings”
  3. Press “Select”
  4. Cycle to “Date/Time”
  5. Press Select.
  6. You will see the factory default Date, press “Select” again to edit.

How do I start my Pentair pool pump?

1. Be sure the pump is powered on and the green power LED is on. 2. Select one of the speed buttons, then press the Start/Stop button (LED on) to start the pump.

How do I reset my Pentair easy touch?

Right button: Press the Right button to reset system. The main screen will be displayed and communication will be established with the optional EasyTouch Indoor Control Panel if installed.

Why is my water pump not working after power outage?

Often when there is no water after a power outage it is due to the low-pressure switch. This is because the tank has to have a certain amount of pressure to keep the water levels where they need to be. When there is no power, the pressure drops and causes the pressure to drop. This then causes the water levels to drop.

Leave a Comment