How do I reset my Pentair Intelliflo VSF pump?

by

>> Click to read more <<

Consequently, how do I log into Pentair ScreenLogic?

To connect to your system via your local network:

  1. Enter your ScreenLogic system name in the “System Name” box. …
  2. Click the “Options” button. The ScreenLogic Connect program. …
  3. Click the “Remember Login info” check box to save your. …
  4. Click the “Start ScreenLogic” button to connect to your system.
Beside above, how do I reset my Pentair Intelliflo pump after a power outage? How to “restart” your pool once power is restored

  1. Remove the pool cover and check for debris. …
  2. Close any drain plugs or valves you may have opened during the power outage.
  3. Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on.

In this regard, how do I reset my Pentair easy touch?

Right button: Press the Right button to reset system. The main screen will be displayed and communication will be established with the optional EasyTouch Indoor Control Panel if installed.

How do I reset my Pentair pool timer?

How to Set the Date/Time on the Pentair Intelliflo

  1. From the home screen, press the “Menu” button.
  2. Use the Up or Down Arrows to cycle to “Settings”
  3. Press “Select”
  4. Cycle to “Date/Time”
  5. Press Select.
  6. You will see the factory default Date, press “Select” again to edit.

6 Related Question Answers Found

How do I program my Intelliflo VSF pump?

How do I create a Pentair username?

How do I reset my ScreenLogic protocol adapter?

unplug and plug back in the wireless router to reset it. 3. Verify the wiring to the protocol adapter and IntelliTouch Load Center.

How do I reset my Pentair Intelliflo pump password?

Make sure the pump has power, green LED is on. Make sure the pump is not running. Press and hold all of the four Speed buttons simultaneously for four (or more) seconds. Power off the pump, wait a few seconds, power it back on.

How do I reset my pool?

How do you reset Pentair?

TO PERFORM A FACTORY RESET:

Press Start/Stop to stop the pump. 2. Record all of the custom schedule settings and the priming speed in Table 3. These settings can be found by pressing the “1”, “2”, “3”, and “Quick Clean” buttons and cycling through all the screens.

Leave a Comment