TO PERFORM A FACTORY RESET:
Press Start/Stop to stop the pump. 2. Record all of the custom schedule settings and the priming speed in Table 3. These settings can be found by pressing the “1”, “2”, “3”, and “Quick Clean” buttons and cycling through all the screens.
Additionally, should I turn off my pool pump when it freezes?
Run your pool pump continuously when temperatures are near or below freezing. You don’t need to run your heater, moving water likely will not freeze. Disconnect any aerators and lines to slides. Booster pumps for pool cleaners don’t need to run continuously.
In this way, how do I reset my Pentair Intelliflo variable speed pump?
To reset the pump to the factory default settings:
- Ensure that the pump is powered on and the green power LED is on.
- Press the Stop button to stop the pump.
- Press and hold all of the four Speed buttons simultaneously for four seconds. Power off the drive.
How do you set the Pentair pool pump timer?
How do I reset my pool?
How do I reset my Pentair Intelliflo pump after a power outage?
How to “restart” your pool once power is restored
- Remove the pool cover and check for debris. …
- Close any drain plugs or valves you may have opened during the power outage.
- Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on.
How do I program my Pentair variable speed pump?
Why is my water pump not working after power outage?
Often when there is no water after a power outage it is due to the low-pressure switch. This is because the tank has to have a certain amount of pressure to keep the water levels where they need to be. When there is no power, the pressure drops and causes the pressure to drop. This then causes the water levels to drop.
How do I start my Pentair pool pump?
How do I reset my Pentair easy touch?
Right button: Press the Right button to reset system. The main screen will be displayed and communication will be established with the optional EasyTouch Indoor Control Panel if installed.
Why is my pool filter not turning on?
When a pump doesn’t turn on or starts shutting off quickly after it’s started, it’s usually an electrical problem, which could mean loose connections, a bad capacitor or overloaded voltage. But it could also be a jammed motor.