How long do pool pumps last? Your pool pump should be replaced anywhere between 8 to 15 years depending on the quality, and a full replacement may cost over $800. Your pool pump is the “heart” of your swimming pool as it circulates water throughout, bringing water through the filtration and heating systems.
Subsequently, is a 1.5 HP pool pump good?
With that in mind, a 0.5-horsepower pump with 40 feet of head resistance is suitable for small pools up to 11,000 gallons. A 1-horsepower pump with the same resistance will work for pools up to 26,000 gallons, while a 1.5-horsepower pump is suitable for large pools up to 30,000 gallons.
Herein, can I replace my pool pump myself?
A professional electrician will be needed to disconnect the wiring before a pump can be removed. Once a new pump is installed, an electrician will again be necessary to reconnect the wires to the new pump. A do-it-yourself homeowner with basic mechanical aptitude can replace the pool pump in a relatively short time.
How can you tell if your pool pump is going bad?
Signs You Need Pool Pump Replacement
- Rumbling Sounds. An excessively-vibrating pump motor can create these rumbling sounds. …
- Grinding or Screeching Sounds. …
- Blowing Bubbles and Spitting Water. …
- Old Age. …
- Get a New Pool Pump Now to Keep Enjoying Safe Water.
Can a pool pump be too big?
You might think bigger is better in terms of pump size, but a pump that is too big can cause serious problems. In the example above, the pool’s average depth is 8 feet. Now use the formulas below to determine the volume of water in your pool.
What is the normal pressure of a Hayward pool pump?
Generally speaking, a pressure reading between 10 – 25 psi can be considered normal. Once you have installed a new filter, turn everything on and take a baseline reading. Each time that you change your pool filter take a new baseline reading.
What size pump do I need for a 30 000 gallon pool?
So, for a 30,000-gallon pool that runs continuously (24-hours), the formula is: 30,000 x 2 ÷ 24 ÷ 60 = 41.6 or rounded up it’s a 42 GPM minimum flow rate. To establish the max flow rate needed for your swimming pool, I like to go by filter surface area.
What size pump do I need for a 15000 gallon pool?
A 15,000-gallon pool needs about 20 GPM output if we want to run it 24 hours per day. Most people run their pool on an 8-hour on/16-hour off (stagnant) cycle.
Can I replace a 1.5 HP pool pump with a 2.0 HP?
Pool owners often mistakenly believe if they choose a 2 HP pump over a 1 HP pump, they are getting double the performance. This is simply not true. In this scenario, you will get only about 15% more flow from the 2 HP model. But the amp draw of the larger pump will be significantly higher, raising your electric bill.
What is the difference between 1 HP and 1.5 HP pool pump?
So, on low speed the 1 HP moves 43 GPM and the 1.5 HP moves 45.5 GPM. To save money you want to hopefully run it on low speed (much less electrical current is used on low speed and it’s more quiet).
Can my pool pump be too powerful?
The more powerful your pool pump is—the more horsepower it has—the faster it will turn the water over, which means you can run it less often and for shorter periods of time. But this is also dependent upon the size of your filter and the filtration system’s pipes. A too-powerful pump can be too much for a small filter.
How much does a 1.5 HP pool pump cost?
$1.36 per day x 365 days = $496 per year to Operate a 1-½ HP Variable Speed Pump. Cost to Operate 1-½ HP Single Speed Pool Pump $1,062 / yr Vs. Cost of Variable Speed Pump $496 / year.
Can you oversize a pool pump?
The only real problem with an oversized pump is that it uses more electricity than a smaller pump would to do the same job. Unless you have a spa or waterfall or some other water feature, a 2 HP pump is larger than what you really need and costs more to run than a smaller pump would cost.
How do you remove the impeller from a Whisperflo pump?
What size pump do I need for a 24 above ground pool?
Round Above Ground Pool:
For pools up to 24 Ft Round, use a 1 HP pool pump. For pools over 24 Ft Round, we recommend using a 1.5 HP pool pump.
What is the difference between 1hp and 1.5 hp motor?
So, on low speed the 1 HP moves 43 GPM and the 1.5 HP moves 45.5 GPM. To save money you want to hopefully run it on low speed (much less electrical current is used on low speed and it’s more quiet).
Are 2 speed pool pumps worth it?
At River Pools, we used two speed pumps for years with great success. They are quite a bit more expensive to purchase than single speed pumps and last the same amount of time, which is typically 3-8 years. On average, a two-speed pump will save about 50%-70% on energy cost compared to a one-speed pump.
How long do Pentair pool motors last?
Old Age. Well-maintained high-quality pool pumps can last between eight to 12 years. If you’ve missed out on many critical pool services, however, you can expect your pump to fail sooner.
What size pump do I need for a 30 000-gallon pool?
So, for a 30,000-gallon pool that runs continuously (24-hours), the formula is: 30,000 x 2 ÷ 24 ÷ 60 = 41.6 or rounded up it’s a 42 GPM minimum flow rate. To establish the max flow rate needed for your swimming pool, I like to go by filter surface area.
Which is better Pentair vs Hayward?
When it comes down to it, both pumps have their own strengths and weaknesses. The Hayward EcoStar has better energy efficiency and the Pentair IntelliFlo has a reputation for longevity with a proven track record. It’s a close battle between the two pumps and it really comes down to personal preference.
How many gallons per minute does a 1.5 HP pool pump?
For each 1.5 inch intake line, the maximum flow into the pump will be 42 gallons per minute (GPM).
How long do Pentair pool pumps last?
How much water does a 1.5 HP pump?
My 1.5 HP pump pumps approx 14 L/min and I have purchased 40L/min flow sensors. My system will have a 3.2″ TFT and 2 flow sensors. The reservoir and high level tank water levels will be displayed graphically.
How long do you need to run a pool pump?
The rule of thumb is generally 8 hours, although it could be anywhere from 6-12 hours, depending on your pool’s size. Each pool is unique, so to keep your pool pump efficient and effective, you need to figure out exactly what your pool’s turnover rate is.
What is the difference between 1hp and 2hp motor?
One horsepower equals 1.36 Newton-meters of torque at 5252 RPM. A two horsepower motor would have 2.36 Newton-meters of torque at 5252 RPM. A typical 1 HP 2875 RPM motor would have 2.49 Newton-meters of torque.
Can I replace a 1.5 HP pool pump with a 1hp?
Yes. You can, but what’s more important to answer is do your really NEED to change your pump to one with a higher horsepower rating? If you have complete information on you pool and you’ve determined that your current pool pump is not enough for your needs, by all means, go ahead and change your pool pump.
Does a pool pump use a lot of electricity?
One of the most significant consumers of energy in homes with swimming pools are pool pumps, which keep pools clean by circulating water through filters. Pool pumps can consume 3,000 to over 5,000 kWh per year.
Can I replace a 1.5 HP pool pump with a 2hp?
Pool owners often mistakenly believe if they choose a 2 HP pump over a 1 HP pump, they are getting double the performance. This is simply not true. In this scenario, you will get only about 15% more flow from the 2 HP model. But the amp draw of the larger pump will be significantly higher, raising your electric bill.
Can I replace my 1 HP pool pump with a 1.5 HP?
So to answer the question, yes, you can replace your 1hp pool pump with a 1.5hp pool pump, but only if your situation calls for it. If you’ve determined that your current pump is too small for your pool, then we’ll suggest replacing it with a larger ECO pump like the Water TechniX Pump Alpha ECO.
How long should a Hayward pool pump motor last?
What is the flow rate of a 1.5 HP pool pump?
This product by Hayward is a 1.5hp pool pump designed to pump up to 90 GPM in most pools. It requires less maintenance and is highly efficient.
How long does a Hayward pool pump last?
Your pool’s pump is the wet end of the operation, it houses the pump basket. Pumps should last through the initially installed motor and perhaps as many as two or three replacement motors, usually 10-12 years.
How many hours should my pool pump run?
How do you know if your pool pump motor is bad?
Don’t Wait to Call for Swimming Pool Pump Replacement
- Age. Yes, the age of your pump is an early trouble sign. …
- Noise. Your pool pump should run quietly. …
- Power Trip. Has your pool pump motor started to trip your electric breaker box more and more frequently? …
- Swimming Pool Pump Motor Keeps Shutting Off. …
- Loss of Suction.
What size pump do I need for my pool?
Divide the pool volume by the number of hours that you would want the pump to be running, so that would be 65,947.5 divided by 6. This would give you 10,991 which means your pump should be able to turn around this much water in 6 hours.
What happens if your pool pump is too big?
Too large of a pump can cause poor filter performance and even damage it, if the filter is not also oversized accordingly. Another possible consequence is pump cavitation in which bubbles form in the water inside the pump and then burst with great force, resulting in damage to the impeller and other internal parts.
How much electricity does a 1.5 HP pool pump use?
It’s not uncommon for a 1.5 horsepower pump to use 1500 – 2000 watts. This is unfortunate, because most pools only need 1/4 to 1/8th horsepower for circulation. Higher power may be needed for tasks like vacuuming the pool. Modern pool pumps like the EcoPump offer a circulation mode, and a vacuum mode.
Can a pump be too big for a pool?
You might think bigger is better in terms of pump size, but a pump that is too big can cause serious problems. In the example above, the pool’s average depth is 8 feet. Now use the formulas below to determine the volume of water in your pool.
How much does a Hayward pool pump cost?
Does pool pump use a lot of electricity?
One of the most significant consumers of energy in homes with swimming pools are pool pumps, which keep pools clean by circulating water through filters. Pool pumps can consume 3,000 to over 5,000 kWh per year.
Where are Pentair pool pumps manufactured?
Our manufacturing plant, located in St. Paul, Minneapolis, USA, produces products for fluid processing, respiratory, membrane, blood line and systems.
Is Hayward a good pool pump?
Hayward SP2610X15 1.5 HP Inground Pool Pump — Best Overall
It is recognized across the industry as one of the best inground pool pumps due to its reliability and performance. On top of this, it is extremely efficient thanks to its balanced Noryl impeller.
Can you replace a 1.5 HP pool pump with a 2hp?
Pool owners often mistakenly believe if they choose a 2 HP pump over a 1 HP pump, they are getting double the performance. This is simply not true. In this scenario, you will get only about 15% more flow from the 2 HP model. But the amp draw of the larger pump will be significantly higher, raising your electric bill.
How much does labor cost to replace a pool pump?
Swimming Pool Water Pump Costs
Item | Cost |
---|---|
Pump | $900-$1,500 |
Labor Cost | $250 |
Total Cost | $1,150-$1,750 |
Who makes WhisperFlo pool pumps?
How do you wire a Pentair Whisperflo pool pump?
How many gallons per hour does a 1.5 HP pool pump?
Pump Size | GPM (varies with plumbing) | Cost/Hour |
---|---|---|
0.5 HP | 40 | $0.03 |
1.0 HP | 60 | $0.06 |
1.5 HP | 68 | $0.09 |
2.0 HP | 76 | $0.12 |