Flipping the switch initially turns your light on. Turning the switch off then on again will set the light to the second color. Repeating this procedure allows you to cycle through the various colors and light shows easily. Keep turning the switch off then on again until you have reached your desired setting.
Moreover, how does a Hayward pool light work?
To activate the light, simply turn on the switch. To deactivate the light, turn off the switch. To advance to the next light program (fixed color or color show), turn the switch off, then back on within 10 seconds.
Beside above, how do you turn the lights on a Hayward pool?
CENTER KNOB – To turn the lights on, briefly push on the CENTER KNOB. To turn the lights off, push in and hold for 3 seconds. To change a show or color, rotate the CENTER KNOB to the desired show/color and push the CENTER KNOB briefly to save.
Why is my pool light not working?
Check the circuit breaker panel that’s usually found on the side of your house. If the breaker that your pool light is on has been tripped, unplug whatever you just turned on or plugged in and then reset the breaker by turning it all the way off and then back on again. If that doesn’t work, you may have a bad breaker.
How do I control my pool lights?
How long should a Hayward LED pool light last?
Most incandescent bulbs will burn for 1,000 hours before bulb replacement is necessary. LED bulbs can burn for 25 years or more (or so they tell us).
How do I change the LED light in my pool?
What Are The Steps Involved?
- Step 1: Safety First! Turn Off the Power. …
- Step 2: Remove the Top Screw from the Light. …
- Step 3: Pry the Light Fixture Out. …
- Step 4: Test the Wiring. …
- Step 5: Take the Fixture Apart. …
- Step 6: Remove the Old Light Bulb. …
- Step 7: Screw in the New Light Bulb. …
- Step 8: Test the Light.
Why does my LED pool light flicker?
Dead Bulb. If your pool light bulb is flickering or turned off and the housing is still dry, it may be that the bulb just needs replacing. Be careful, though, because if the bulb isn’t lasting as long as it should that is an indicator of a much worse problem such as a power surge or some faulty wiring somewhere.
How do you change the color of your pool?
How do you reset the LED light on a Hayward pool?
To re-synchronize your lights, turn the switch on, then back off, then wait between 11 and 14 seconds and turn the switch back on. When the lights come back on, they should enter program #1, and be synchronized.