Why is the flow light red on IntelliChlor?

The “cell” light will only come on when it’s making chlorine. If the red flow light is lit, the SWCG “thinks” there is little or no water flowing through it and will no operate, no matter what. If it’s under warranty, give Pentair a call.

>> Click to read more <<

Accordingly, how do I know if my IntelliChlor flow switch is bad?

A suspected bad flow switch can be confirmed by cutting the black and red wires and connecting them together coming out of the cell. If the cell operates with the wires connected this confirms the flow switch was bad.

People also ask, why won’t my pool pump circulate water? Low pressure means there is a clog somewhere. High pressure indicates it needs to be backwashed or the filter cleaned. If you have low pressure, it is possible something got through the baskets or pump pot and clogged the impeller. This is common.

Subsequently, how do I know if my Pentair salt cell is bad?

If the salt cell bubbles, but only a little bit, then you probably have a bad cell. It is still a good idea to call a pool professional to confirm this diagnosis. If the salt cell bubbles vigorously, then it is working fine.

How can I tell if my Pentair IntelliChlor is working?

2. If the cold water light “flashes” “red” it is telling you that the temp sensor is reading a temperature of 100 plus degrees. Then you can compare the water temperature with a thermometer to see if the IntelliChlor sensor is reading correctly.

How do I reset my Pentair IntelliChlor?

Press and hold the “More” button for 3 seconds to enter system status mode. All the lights will scroll across the panel, and then go dark. Only the “Power”, “Cell”, “Life”, and “Low” lights will be lit.

What is chlorinator low flow error?

The most common reason for low or no flow is that the baskets are full of debris. By checking and emptying both the skimmer basket (by the pool) and the pump basket (inside the pump) will free up the water flow, allowing the system to fully ‘prime’ and function at full capacity.

Why is my Pentair salt Cell blinking red?

If CELL LED has a “short flash RED”, the unit has deteced a malfunction on the temperature sensor and the Flow Switch needs to be replaced. 8. The SALT LED will flicker between RED to GREEN for about 2 minutes as it takes readings. After 2 minutes the SALT level LED will display.

How do I turn off my Pentair salt Cell?

Turn your SCG breaker to off and unscrew/unplug the cable from the bottom left of the load center. Then you can unscrew the two unions on the cell and remove from system.

Why is my Intellichlor not producing chlorine?

The saltwater chlorinator needs a sufficient flow of water for effective operation. A dirty skimmer basket, clogged or dirty filter, and a clogged pump strainer, can cause insufficient water flow for the chlorinator to produce less chlorine.

How do I test my pool flow switch?

You can test the continuity of the flow switch using a Voltmeter or Ohmmeter. Continuity is open if there is no flow. Alternatively, continuity is close if sufficient water flow is detected.

Why is my pool pump not flowing?

It could be something blocking it, a dirty pool filter, or too much air in the system. If there’s something blocking your pump’s suction, check your filter gauge. If it’s 10psi above the normal reading, clean your filter. This will reduce pressure and reset your pump’s flow.

What should my Pentair salt cell be set at?

The IntelliChlor SCG is designed only to produce chlorine. The IntelliChlor SCG does not monitor or control chlorine levels in the pool or spa water. It is the pool ownerʼs responsibility for monitoring and maintaining free chlorine levels at the APSP recommended range of 2.0 to 4.0 parts per million (ppm).

Leave a Comment