Push the “POOL” button to activate the unit and then set the pool Heat Pump thermostat to a temperature higher than the current pool water temperature. 5. Allow 5 Minutes for the Heat Pump to start.
Also question is, how do I use my Hayward pool heater?
One may also ask, what does LP mean on a Hayward heat pump?
low-pressure
In this regard, what does PS mean on Hayward pool heater?
Adequate water flow through the heat pump causes the Water Pressure Switch contacts to close. Insufficient water pressure will allow these contacts to open, and turn the heat pump off. The display will read “PS” if the water pressure is not sufficient.
Where is the pilot light on Hayward pool heater?
What does AO mean on my pool heater?
Blower vacuum switch open error
Why is my Hayward pool heater not working?
If the heater has not been fired in over a week, chances are there is a blockage in the burners or orifices that is preventing the gas from escaping the burner and reaching the spark. Other causes of this problem are: (1) Bad ignitor. (2) Bad gas valve.
How do you turn on a Hayward pool pump?
How to Operate a Hayward Pool Pump
- Ensure the hoses are securely attached. …
- Check the skimmer water level. …
- Add water to the pump basket. …
- Open the air valve. …
- Confirm that the necessary cleaning agent is in the filter. …
- Monitor the filter’s pressure gauge and water return flow.