Vince

Which type of robot automatically cleans a swimming pool?

by

Which type of robot automatically cleans a swimming pool? To keep inground pools clean and algae-free, the Dolphin Nautilus CC Plus Automatic Robotic Cleaner is an excellent option with powerful suction and an efficient cleaning cycle.

Why is my pool pump leaking from the bottom?

by

Why is my pool pump leaking from the bottom? In most cases, a leak underneath a pool pump is caused by a pressure-side leak. This is easily combated by inspecting the impeller housing o-ring, shaft seal and replacing any worn, cracked o-rings or seals. Before taking apart your pool pump, we recommend purchasing a go-kit.

Why is my Hayward pool pump not turning on?

by

Why is my Hayward pool pump not turning on? When the breaker trips when trying to turn on the pump, most likely the motor shaft is frozen, the impeller is stuck, or the capacitor has blown. In some cases, it can be a bad breaker, especially one that is used often to turn the pump on and off.

What size pump do I need for my pool?

by

What size pump do I need for my pool? Sizing the Pump for Your Swimming PoolCircular Pools: Diameter (ft.) x Diameter (ft.) x Average Depth (ft.) x 5.9 = Total pool capacity in gallons.Oval Pools: Length (ft.) x Width (ft.) x Average Depth (ft.) x 6.7 = Total pool capacity in gallons.Rectangular Pools: Length (ft.) x Width (ft.) x Average Depth (ft.)

How do I reset my dolphin pool cleaner?

by

How do I reset my dolphin pool cleaner? Turn the power supply OFF. Wait 30 seconds, then turn it back on. Pool Cleaner does not move / Red light on the power supply. The blue floating cable is not connected into the power supply.

Why is my Hayward pool pump so loud?

by

Why is my Hayward pool pump so loud? One of the most common causes for a noisy pump is that it’s running dry. This can happen for a few reasons—the most common of which have to do with the skimmer plate built into the side of the pool. If your pool water level has fallen below halfway down the skimmer, your pump might be sucking in air as well as water.

Why won’t my pool pump keep pressure?

by

Why won’t my pool pump keep pressure? It could be something blocking it, a dirty pool filter, or too much air in the system. If there’s something blocking your pump’s suction, check your filter gauge. If it’s 10psi above the normal reading, clean your filter. This will reduce pressure and reset your pump’s flow.