Who makes Dolphin S200?
Who makes Dolphin S200? Manufacturer Maytronics
Who makes Dolphin S200? Manufacturer Maytronics
Can I leave my Dolphin pool cleaner in the pool? This will help protect the Dolphin from surges in power such as thunderstorms. Can you leave the Dolphin in the water? It is safe to leave your Dolphin cleaner in the water when not in use. However, (when adding chemicals to the pool) please remove the Dolphin until the proper chlorine and PH balance are obtained.
What do you do if your pool pump won’t prime?
How do I change tracks in Dolphin?
What is caddy for pool cleaner? The caddy provides a proper storage solution and keeps pressure off the scrubbing brushes, allowing them to maintain their form.
Why is my Hayward pool Vac not moving? There is an obstruction in the cleaner. Remove the consumer inspection plate at the bottom of the cleaner (one self contained screw needs to be loosened) and see if a rock, twig or large piece of debris has stuck between the bearings and turbine. Shake the head of the cleaner to dislodge any internal debris.
Why is water coming out of my backwash? Another reason for a leak through the backwash hose is if the spider gasket (spoke gasket) is damaged or worn out. A damaged spider gasket will be unable to carry out its functions. Also, it will take very little water pressure to move a damaged or worn-out spider gasket out of place.
How do I reset my pool heater? Reset the breaker for the electrical circuit to the pool heater by flipping the breaker switch to the “Off” position and then to the “On” position. Typically, the breaker is at a disconnect box near in the heater and filter enclosure or may be at the breaker panel for the house.
What chemicals do I need to put in my above ground pool? Things you’ll be testing for include chlorine, PH, total alkalinity, Cyanuric acid (stabilizer), and calcium hardness. The levels need to be properly balanced for safe and clean water before swimming in it. The free chlorine level should be between 2.0 and 4.0 ppm. The PH level should be between 7.2 and 7.8.
How do you fix a Pentair pump?