Never Use the Pool Pump to Drain the Pool
This is where water enters the filtration system, which is powered by the pump. And pool pump motors are water-cooled devices. If you use the pump to pull water from the pool, as soon as the water level falls below the skimmer, your pump will start pulling in air.
Keeping this in view, where do you drain pool water?
The first choice for draining swimming pool water should be to drain pool water into the sanitary sewer. In-ground pools typically have a sanitary sewer drainage inlet near the pool equipment. Pools and spas not plumbed with a sanitary sewer drainage inlet can be drained to a sanitary sewer line plumbed to the home.
In this regard, how can I drain my pool without flooding the yard?
All you need is a medium-size water or vacuum pump.
- Unroll the pump’s intake hose so that it reaches the center of the pool (or as close to it as possible), and submerge it in the pool.
- Place the outlet hose so the exiting water doesn’t flood the area, but drains off away from the pool.
- Dry your hands thoroughly.
How do you drain a pool with a sand pump?
How do you drain a Pentair filter?
Shut off the pump. Go to the back of the filter and unscrew the drain plug. Turn the pump back on and let the water run until it reaches the point where you want to drain the water out. Turn the pump back off and put the plug back into the drain plug.
How do you drain an inground pool below skimmer?
Turn the filter off (or unplug it) and set it to Waste. Shut off your skimmer and open your pool’s main drain. Turn your filter on and the water will start to pump through your backwash hose. Allow the water to drain.
How do I drain the sand in my pool filter?
How do you drain a sand filter?
Drain the Tank
Remove the drain cap at the bottom of your filter tank to release the pressure in the filter and drain the water. Give the drain cap at the bottom of the tank just half a turn counter-clockwise to let out all the air. After a burst of air pressure, remove the cap to drain out the water.
How long does it take to drain a pool with a garden hose?
If you can pump around 30 GPM (gallons per minute), which is also equivalent to 1800 GPH (gallons per hour), it should take you 2.78 hours or 2 hours and 46 minutes to drain your pool using a hose.
How do I drain excess water from my pool?
How to Drain Water from Your Pool after Rain
- Clean the Pool Deck. Sweep up debris from the pool deck, and use a garden hose to clean it of dirt. …
- Manually Remove Debris from the Pool. …
- Turn On the Pump and Filter. …
- Brush the Pool. …
- Vacuum the Pool. …
- Drain Some of the Water from the Pool. …
- Test and Balance the Water.
How do you pump water out of a pool with a hose?
To drain your pool with a hose, just place its one end inside the port and connect the other end to a submersion pump. Submerge the hose and pump in the pool’s deepest part, preferably close to the drain.