Open the filter covers and remove the cartridges from both sides of the robot. Open the clips and remove the filters. Clean the filters with a hose.
Likewise, people ask, how often should I run my dolphin pool cleaner?
Ideally, you need to run your robot pool cleaner daily or at least once a day if you’re always swimming in it. But if you don’t swim in it as much, run it at least once weekly or every two weeks. When you’re using a swimming pool cover all the time, you may wash your pool monthly.
Then, how do I clean my dolphin pool cleaner filter?
How do you use the Maytronics dolphin?
Just drop it in your pool, turn it on and leave it for about 5 hours. It computes a path to maximize cleaning and even climbs the walls to scrub and vacuum the entire pool floor, walls and waterline.
How many hours per day should I run my pool cleaner?
The rule of thumb for pool maintenance is to run your pump for eight hours per day.
How do I use Maytronics Pool Cleaner remote?
Using the remote control
- Press the On/Off button once. The remote control will start in manual direction control mode.
- Use the direction control arrows (see right) to control the movement of the robot around the pool.
- To exit the manual direction control mode, press the Manual/Automatic select button once only.
Can I leave my dolphin pool cleaner in the pool overnight?
While the unit can remain in the pool during use of the weekly timer function (if available on your model), we do not recommend leaving the cleaner in the pool for long extended periods of time.
Can I use a dolphin M400 in an above ground pool?
M400. Designed for small In-Ground & Above-Ground Pools.
Why does my dolphin pool cleaner do wheelies?
What causes automatic pool cleaners to flip or do wheelies? The water level in a pool is one of the most common causes for this problem. When the water level is too high, the water line is very close to the coping. So when the cleaner starts to climb the wall, it hits the coping and flips on to its back.
How do I adjust my dolphin pool cleaner?
To adjust the handle angle:
- Lay the handle down at an angle of 180º to the ground.
- Push the base of the arm into the body of the robot pool cleaner and slide it towards the rear of the robot pool cleaner until it clicks into the required position.