Pressing the Reset button will clear the alarm once the fault condition has been resolved. In the event of a warning: The warning light ” ” will illuminate, but the pump will continue to run. The speed, flow or pressure limit that is causing the warning must be adjusted in order to correct the warning.
Additionally, how do I reset my Pentair Intelliflo pump after a power outage?
How to “restart” your pool once power is restored
- Remove the pool cover and check for debris. …
- Close any drain plugs or valves you may have opened during the power outage.
- Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on.
Just so, why does my Intelliflo pump keep shutting off?
It could be a bad drive, over voltage, under voltage, drive over heating, ect. You could eliminate it being a control problem by unplugging the control cable on the motor, and manually running it. If it does not do it anymore then it is a control issue.
How do I reset my Pentair Intelliflo pump?
Why does my Pentair pump keep stopping?
There are several reasons why your pump may randomly shut off—a behavior known as “pump tripping.” Most commonly, your pump may be operating at the wrong voltage, overheating, or simply failing to compete with your neighborhood’s electrical needs.
How do I program Intelliflo VF?
How do you set a Pentair pool pump to run continuously?
How do I reset my pool pump?
Steps to Prime Your Pool Pump
- Turn off the pump. …
- Switch to recirculate. …
- Release air. …
- Clean out the pump basket. …
- Fill the pump basket. …
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.