How do I control my pool heater with my phone?

>> Click to read more <<

People also ask, how do you use a Hayward gas pool heater?

Likewise, how do I connect my pool to my phone?

In this way, how does Hayward Aqua Connect work?

The Aqua Connect Home Network (ACHN) is a communications gateway that allows a Hayward pool controller to connect to a home network and, if desired, the Internet. HOME NETWORK:Any home PC connected through the same router as the ACHN can become a pool control terminal.

How do I control my Hayward pool heater?

How do I connect my Hayward to WIFI?

Press the “wifi bridge” option on the right side of the screen. NOTE: The network password IS CASE SENSITIVE. To confirm connection, go to Config>Network and verify IP addresses appear under the dynamic tab. To change, select the IP address, enter new value, and select check to save.

How does Hayward pool remote work?

How do I use the AquaLink app?

How do I control my pool heater?

How do I turn on my Hayward heat pump?

Push the “POOL” button to activate the unit and then set the pool Heat Pump thermostat to a temperature higher than the current pool water temperature. 5. Allow 5 Minutes for the Heat Pump to start.

How do I connect my aqua to WIFI?

Setup Web Control

Press and hold the “Teach” button. Continue to hold the “Teach” button WHILE plugging in the power cord. Keep pressing the “Teach” button until all four LEDs blink in unison, then release button. Place the Aqua Connect Home Network in a desirable location close to the home network router.

How do I connect my Hayward Aqua Connect app?

Press the Menu button on the ProLogic system until the Settings Menu appears, then press the left arrow button until “Teach Wireless: + to start” appears. Press the “+” button to initiate the sequence on the controller and hold down the teach button on the Aqua Connect Home Network device.

Leave a Comment