Use a pool brush to vigorously scrub any pool surfaces covered in algae, including the walls, floors, and steps. Apply a green algaecide according to the directions on the label. Let the water circulate for 24 hours, then brush the pool surfaces again. Vacuum or backwash to remove any remaining dead algae.
Similarly, how do I get algae off the bottom of my pool without a vacuum?
A nylon or rubber brush is the correct choice for scrubbing the sides of a soft-sided above-ground pool. A large pool brush makes quick work of the job, but you may need a smaller brush to clean corners. Once the particles have been removed from the sides of the pool, turn your filter back on and agitate the water.
- Test and Balance Water. Always begin by testing your pool water. …
- Clean Pool Water and Surfaces. Skim water surface to remove visible debris, brush walls, vacuum and empty skimmer baskets. …
- Apply a Shock Treatment. …
- Apply an Algaecide. …
- Clean Filter.
Also to know is, what naturally kills algae?
Grab a brush and some baking soda. Bicarbonate, the active ingredient in baking soda, is an effective spot treatment to help kill the algae and loosen it from the wall. Make sure you really get every last particle free; black algae has particularly long and stubborn roots which makes it a persistent strand.
Can you swim in a pool with algae?
Algae can be very slippery, causing swimmers to fall resulting in bumps, bruises, cuts and even broken bones. Don’t try to swim in a pool that’s full of algae. Besides causing injuries, an algae infested pool creates a higher risk of drowning for those who are not expert swimmers or those who fall unconscious.
Can you vacuum algae out of a pool?
Set up your waste line and vacuum the pool to waste getting the algae and debris out of the pool. Don’t let the water level get too low during this process, if it gets more than 6 inches below the tile, stop. Turn the system off and refill the pool and repeat until the whole pool is vacuumed.
What is the fastest way to get rid of algae in a pool?
Getting Rid of Pool Algae
- Step 1: Check the Water Levels. …
- Step 2: Clean the Pool Filter. …
- Step 3: Brush the Pool. …
- Step 4: Shock the Pool. …
- Step 5: Test the Water. …
- Step 6: Add Algaecide. …
- Step 7: Brush the Pool Again. …
- Step 8: Vacuum the Pool.
Why is my pool green with high chlorine?
When the levels are properly balanced, chlorine will keep the algae at bay, but the water will slowly begin to turn green as the algae take over if there’s not enough. But be careful—adding too much chlorine in pool water can cause those metals to oxidize and turn the pool a different shade of green.