The easiest way to identify your multiport valve is to find a manufacturers part code, this is normally found along the front face of the multiport valve. Once you have identified this number we can then use it and match it up to a valve that suits your pools filtration system.
Accordingly, how do you fix a leaking multiport valve?
If it’s still leaking, remove all cover screws and pull out the key assembly. Clean, inspect and lubricate the large cover o-ring and place back into the groove in the key assembly. Replace the key into the valve and tighten up the cover screws, then fire-up the pump to check for leaks.
- Turn off all pool/spa equipment.
- Rotate valve handle so the OFF on the handle is. …
- Unscrew (counterclockwise) and remove the. …
- Fill cap with lubricant (Jandy Lube).
- Replace cap on fitting and turn in (clockwise) …
- Move the handle from side to side to spread. …
- Reset the valve handle to its original position.
Considering this, how long does a multiport valve last?
If the valves are older than 10 years you may want to replace the whole thing versus replacing just handles. Multiport valve manufacturers build their units to be rebuilt, and as long as the main internal parts are okay, the wear out o-rings and gaskets can be replaced.
How do you replace a multiport valve in a pool?
Where is the multiport valve on pool filter?
Located on the top or side of the filter, the multiport valve’s numerous settings direct the pool water where you need it to go, allowing you to use the filter for multiple purposes.
When should I replace my pool multiport valve?
Chemical corrosion can weaken the stainless steel spring, and cause it to rust and break. The replacement of a spring is similar to replacing the valve handle, described above. Spider Gasket Replacement: Every 5-10 years, the gasket on a multiport valve may need to be replaced.
How do you lube a Hayward multiport valve?
How much does a Hayward Multiport valve cost?
Hayward SP0714T VariFlo Top-Mount Multiport Valve, Black
| List Price: | $128.51 Details |
|---|---|
| Price: | $111.02 |
| You Save: | $17.49 (14%) |
How do you backwash a pool with a multiport valve?
Backwashing Instructions “Multi Port” Valve System
- Turn Pump Off.
- Rotate Handle To “Backwash” Position (Always Rotate Clockwise)
- Turn Pump On (If You Have A Separate Backwash Valve, You Will Have Open That Line)
- Pour 8oz. ( …
- Backwash Until Site Glass Is Clear Or Between 5 & 15 Minutes.
- Turn Pump Off.
How do I know if my multiport valve is bad?
One common symptom of multiport valve problems is when there is leaking around the valve itself, or when water comes out of the waste line, even when the valve is set to the FILTER position. Multiport valve problems may also be indicated when dirt fails to be trapped by the filter, instead returning to the pool.