Close any drain plugs or valves you may have opened during the power outage. Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on. Ensure your pool pump and filter are working, and then let them run for one hour to begin decontamination.
Keeping this in consideration, how do I manually start my Pentair pool pump?
To operate in Manual mode, press one of the four speed buttons and then press the Start/Stop button. The pump will run the assigned speed for that speed button. Speeds 1-4 can be programmed to run at a certain speed and for a duration of time once a speed button is pressed.
Similarly, how do I reset my Pentair easy touch?
Right button: Press the Right button to reset system. The main screen will be displayed and communication will be established with the optional EasyTouch Indoor Control Panel if installed.
How do I reset Pentair vs pump?
To reset the pump to the factory default settings:
- Ensure that the pump is powered on and the green power LED is on.
- Press the Stop button to stop the pump.
- Press and hold all of the four Speed buttons simultaneously for four seconds. Power off the drive.
How do I reset my Pentair IntelliConnect?
Power down the IntelliConnect for ten (10) seconds to reset access point mode and proceed to Step 14 for recommendations on improving the signal/connection strength.
How do I restart my pool pump?
Steps to Prime Your Pool Pump
- Turn off the pump. …
- Switch to recirculate. …
- Release air. …
- Clean out the pump basket. …
- Fill the pump basket. …
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.
How do I reset my Pentair pool timer?
How to Set the Date/Time on the Pentair Intelliflo
- From the home screen, press the “Menu” button.
- Use the Up or Down Arrows to cycle to “Settings”
- Press “Select”
- Cycle to “Date/Time”
- Press Select.
- You will see the factory default Date, press “Select” again to edit.
Where are Pentair pool pumps manufactured?
Our manufacturing plant, located in St. Paul, Minneapolis, USA, produces products for fluid processing, respiratory, membrane, blood line and systems. Our manufacturing plant located in Houston, TX, USA, produces products for industrial, pneumatic, fluid process, and hydraulic applications.
Is there a reset button on a Pentair pool pump?
TO PERFORM A FACTORY RESET:
Press Start/Stop to stop the pump. 2. Record all of the custom schedule settings and the priming speed in Table 3. These settings can be found by pressing the “1”, “2”, “3”, and “Quick Clean” buttons and cycling through all the screens.
Why is my water pump not working after power outage?
Often when there is no water after a power outage it is due to the low-pressure switch. This is because the tank has to have a certain amount of pressure to keep the water levels where they need to be. When there is no power, the pressure drops and causes the pressure to drop. This then causes the water levels to drop.
Why is there no power to my pool pump?
Reasons for a pool pump not turning on include a circuit breaker that has tripped, the pump or the wiring to the pump could be damaged, the power outage could be ongoing or you could simply have a pump that is not primed correctly.