1. Be sure the pump is powered on and the green power LED is on. 2. Select one of the speed buttons, then press the Start/Stop button (LED on) to start the pump.
Also question is, how do I turn on my Pentair spa pump?
Tap the Home screen Spa icon to display the Spa Pump control settings screen. From this screen tap the Spa Pump button to activate the Spa heat source. A Blue badge displayed on the Spa icon indicates the Pool/Spa pump button has been manually turned on. The Blue badge displays until the pump button is turned off.
Keeping this in consideration, how do I turn on my pool pump?
Remove the pump housing cover to fill the pump chamber and intake line with water. Once you replace the cover, open the air-bleed valve on top of the pool filter. The intake and discharge valves should be open, and you can turn on the pump.
How do you prime a Pentair water pump?
How To Prime Your Pentair Pool Pump
- Turn off power to pump (switch and breaker)
- Using black 3 way valve, turn off Skimmer (main drain on only)
- Remove pump lid.
- Fill pump with water all the way to top.
- Put pump lid back on.
- Turn on Pump.
What do you do if your pool pump won’t prime?
Check the pump lid and pump lid o-ring and make sure they do not have any cracks from age. Lubricate the pump lid o-ring and ensure it is clean. Make sure there are no cracks, chips, or breaks in the pump basket.
How do I get air out of my pool pump?
How to Remove Air From a Pool Line
- Turn off power to the pool pump and pool heater. …
- Rotate the air relief valve located on top of the filter canister counterclockwise to open the valve.
- Close the skimmer valves and leave open the main drain valve.
How do you bleed air from a Pentair pool pump?
How to Bleed Air From The Pool Lines. The trick to bleeding the pool lines of air is to start with all the line valves closed. With the pump running, very slowly open the valves to introduce air into the pump until the pump sucks out all the air.
How does pool pump work?
Water is drawn from your pool by the powerful suction created from the pump. The pump draws the water through the skimmers and drains, removing large debris during the journey. When the pump’s impeller is reached, pressure forces water through the filer, catching any debris not caught by skimmer baskets.
Why is my pool pump not filling up with water?
CLOGGED IMPELLER – Fine debris can bypass the baskets and clog the impeller. The impeller can not pull enough water if it is clogged. You can try unclogging the impeller with a wire hanger. If that is not possible, the pump will need to be taken apart in order to access the impeller.
How do you manually start a pool pump?
Steps to Prime Your Pool Pump
- Turn off the pump. …
- Switch to recirculate. …
- Release air. …
- Clean out the pump basket. …
- Fill the pump basket. …
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.