Keeping water in hose, place hose end over SKIM-VAC hose connection. Insert SKIM-VAC into skimmer and firmly place over basket. Hold SKIM-VAC in place until all air is evacuated from vacuum hose. Once the air is removed, the pump suction will hold the SKIM-VAC firmly in place.
Furthermore, do you remove skimmer basket when vacuuming pool?
Connecting the vacuum system to the pump.
Now, here answers the question earlier: do you leave skimmer basket in when vacuuming pool? YES, you need to remove the skimmer or strainer basket before attaching the open end of the hose to the inlet. Finally, plug the open vacuum hose into the suction port.
Also know, how do you manually vacuum an inground pool?
What setting should my pool pump be on to vacuum?
For routine vacuuming, the filter valve is left in the normal “Filter” position. This directs dirty vacuum water through the pool filter to remove the contaminants, then conveys filtered water through return lines back to the pool. The “Filter” setting is used for light to moderate levels of pool sediment.
How do you vacuum a pool with a Hayward skimmer?
How do you vacuum an inground pool with Hayward pump?
How do you vacuum a pool with a pump?
How To Vacuum the Pool with a Sand Filter
- Remove Large Leave or Debris. …
- Set Up the Pool Vac. …
- Switch on the Pool Pump. …
- Vacuum the Pool. …
- Backwash the Filter. …
- Clean the Skimmer. …
- Reset the Filter Valve to Filter and Turn On the Pump.
How do you vacuum an above ground pool with a Hayward sand filter?
Where do you connect the pool vacuum?
The most common connection locations are the open skimmer, suction port, or filter. An automatic pool vacuum system uses the pool’s natural filtration system to clean it, so it could hook up to several ports since the entire pool uses the filtration system.