How do you factory reset a Pentair Intelliflo variable speed pump?

>> Click to read more <<

Beside this, how do I reset my Pentair Intelliflo pump password?

Make sure the pump has power, green LED is on. Make sure the pump is not running. Press and hold all of the four Speed buttons simultaneously for four (or more) seconds. Power off the pump, wait a few seconds, power it back on.

Similarly one may ask, what is thermal mode on pool pump? This feature allows you to set a speed (450- 3450 RPM) or flow (20-140 GPM) that runs when the IntelliFlo® VSF Variable Speed and Flow Pump goes into Thermal Mode. The temperature level that you wish Thermal Mode to start can also be set. IMPORTANT: This feature is for protection of the pump.

Moreover, how do I set the schedule on my IntelliFlo pump?

How do I program a Pentair IntelliFlo 2 VST?

How do you reset the pool timer after a power outage?

What do you do when the power goes out and your pool freezes?

How do you unlock Pentair pool pump?

TO UNLOCK THE PUMP:

Press and hold the “1” and Quick Clean buttons for atleast 3 seconds. “Enter Loc Code” will scroll across the screen. 2. Use the “1”, “2”, “3” and Quick Clean buttons to enter your four-digit keypad lockout code.

Why does my Pentair pump keep stopping?

There are several reasons why your pump may randomly shut off—a behavior known as “pump tripping.” Most commonly, your pump may be operating at the wrong voltage, overheating, or simply failing to compete with your neighborhood’s electrical needs.

How do I reset my Pentair IntelliConnect?

Power down the IntelliConnect for ten (10) seconds to reset access point mode and proceed to Step 14 for recommendations on improving the signal/connection strength.

How do I reset my Pentair password?

How do I program my Pentair Intelliflo?

How do I reset my Pentair Intelliflo pump after a power outage?

How to “restart” your pool once power is restored

  1. Remove the pool cover and check for debris. …
  2. Close any drain plugs or valves you may have opened during the power outage.
  3. Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on.

How do you reset the time on a Pentair pool pump?

How do I reset my pool pump?

Steps to Prime Your Pool Pump

  1. Turn off the pump. …
  2. Switch to recirculate. …
  3. Release air. …
  4. Clean out the pump basket. …
  5. Fill the pump basket. …
  6. Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
  7. Check the water flow to your pump.

Leave a Comment