Steps to Prime Your Pool Pump
- Turn off the pump. …
- Switch to recirculate. …
- Release air. …
- Clean out the pump basket. …
- Fill the pump basket. …
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.
Also, why will my pool pump not turn on?
When a pump doesn’t turn on or starts shutting off quickly after it’s started, it’s usually an electrical problem, which could mean loose connections, a bad capacitor or overloaded voltage. But it could also be a jammed motor. All of these things are usually fairly simple fixes.
Beside above, how do you start a pool?
Your Swimming Pool Opening Checklist
- Remove, Clean and Store Your Pool Cover. First, remove your pool cover, clean it and store it away securely. …
- Fill Your Pool Up. …
- Clean Out Debris. …
- Inspect and Clean Your Pool Filter. …
- Reinstall Plugs. …
- Prime Your Pool Pump and Filter. …
- Test and Balance the Pool Water. …
- Shock Your Pool Water.
How do you manually run a Pentair pool pump?
To operate in Manual mode, press one of the four speed buttons and then press the Start/Stop button. The pump will run the assigned speed for that speed button. Speeds 1-4 can be programmed to run at a certain speed and for a duration of time once a speed button is pressed.
How do I turn on my Pentair spa pump?
Tap the Home screen Spa icon to display the Spa Pump control settings screen. From this screen tap the Spa Pump button to activate the Spa heat source. A Blue badge displayed on the Spa icon indicates the Pool/Spa pump button has been manually turned on. The Blue badge displays until the pump button is turned off.
How do I reset my Pentair Intelliflo VSF?
To reset the pump to the factory default settings:
- Ensure that the pump is powered on and the green power LED is on.
- Press the Stop button to stop the pump.
- Press and hold all of the four Speed buttons simultaneously for four seconds. Power off the drive.
How do you start a pool for the first time?
How do you set a Pentair pool pump to run continuously?
How do I turn on my pool filter?
Why is my pool pump not working?
It could be something blocking it, a dirty pool filter, or too much air in the system. If there’s something blocking your pump’s suction, check your filter gauge. If it’s 10psi above the normal reading, clean your filter. This will reduce pressure and reset your pump’s flow.