Moreover, how do I program a Pentair?
One may also ask, how many hours should I run my variable speed pool pump?
However, it is important to note that a variable speed pool pump should ideally be running 24 hours a day to ensure proper and optimal water circulation. When your pool pump is not running, the water is sitting stagnant in your pool allowing bacteria to survive and grow.
How do I program a Pentair Intelliflo 2 VST?
How do I set the Pendair IntelliFlo egg timer?
What should my pool pump be set on?
The lever should be on the ‘Filter’ setting most of the time. This is the setting that provides normal pool filtration by pushing the water through the filter media (sand, glass beads or D.E) that then traps any dirt and debris before the water is returned to the pool.
Is it better to run pool pump at night?
It may be cheaper to run the pump at night, but honestly you should run it 1 hour a day per 10 degrees of temperature at least, and it should be during the day. Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up.
What RPM should I run my Pentair pool pump?
Suction cleaners typically run at around 2200-2400 RPM. Heaters require 20 to 40 Gallons Per Minute (GPM) so might run at around half speed or a little higher. You would probably want to run your Spa at up to full speed, 3450, for maximum effect.
How do I set the schedule on my Intelliflo pump?
How do I reset my Pentair IntelliFlo VSF?
To reset the pump to the factory default settings:
- Ensure that the pump is powered on and the green power LED is on.
- Press the Stop button to stop the pump.
- Press and hold all of the four Speed buttons simultaneously for four seconds. Power off the drive.
How do I reset the schedule on my Pentair Intelliflo pump?
How should I program my variable speed pool pump?
How long should I run my Pentair Intelliflo pump?
What is thermal mode on pool pump?
This feature allows you to set a speed (450- 3450 RPM) or flow (20-140 GPM) that runs when the IntelliFlo® VSF Variable Speed and Flow Pump goes into Thermal Mode. The temperature level that you wish Thermal Mode to start can also be set. IMPORTANT: This feature is for protection of the pump.