Likewise, how do I program my Intelliflo VSF pump?
- Ensure that the pump is powered on and the green power LED is on.
- Press the Stop button to stop the pump.
- Press and hold all of the four Speed buttons simultaneously for four seconds. Power off the drive.
Moreover, how do I program my Pentair IntelliFlo VSF?
How do I reset Pentair vs pump?
To reset the pump to the factory default settings:
- Ensure that the pump is powered on and the green power LED is on.
- Press the Stop button to stop the pump.
- Press and hold all of the four Speed buttons simultaneously for four seconds. Power off the drive.
How do I manually start my Pentair pool pump?
To operate in Manual mode, press one of the four speed buttons and then press the Start/Stop button. The pump will run the assigned speed for that speed button. Speeds 1-4 can be programmed to run at a certain speed and for a duration of time once a speed button is pressed.
How do I reset my Pentair Intelliflo pump after a power outage?
Close any drain plugs or valves you may have opened during the power outage. Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on. Ensure your pool pump and filter are working, and then let them run for one hour to begin decontamination.
How do I reset my Pentair Intelliflo pump?
1 Answer
- Make sure that the pump is on.
- Press the stop button – the pump will stop.
- Press and hold the four buttons simultaneously for about 4 seconds. Power off the unit and restart.
- The factory settings will be assigned.
How do I keep my Pentair pump running?
How long should I run my Pentair IntelliFlo pump?
Is there a reset button on a Pentair pool pump?
Why does my Intelliflo pump keep shutting off?
It could be a bad drive, over voltage, under voltage, drive over heating, ect. You could eliminate it being a control problem by unplugging the control cable on the motor, and manually running it. If it does not do it anymore then it is a control issue.
What RPM should I run my Pentair pool pump?
How do I adjust my Pentair pool pump?
How do you set a pool pump timer?
How do you set a Pentair pool pump to run continuously?
What is thermal mode on pool pump?
The sensor for Thermal Mode is in the drive, on top of the motor. This feature allows you to set a speed (450- 3450 RPM) or flow (20-140 GPM) that runs when the IntelliFlo® VSF Variable Speed and Flow Pump goes into Thermal Mode. The temperature level that you wish Thermal Mode to start can also be set.
How do you program a variable speed pump?
How do you manually turn on a Pentair pool pump?
How long should I run my Pentair variable speed pump?
However, it is important to note that a variable speed pool pump should ideally be running 24 hours a day to ensure proper and optimal water circulation. When your pool pump is not running, the water is sitting stagnant in your pool allowing bacteria to survive and grow.
How do you set the time on a Pentair variable speed pool pump?
How to Set the Date/Time on the Pentair Intelliflo
- From the home screen, press the “Menu” button.
- Use the Up or Down Arrows to cycle to “Settings”
- Press “Select”
- Cycle to “Date/Time”
- Press Select.
- You will see the factory default Date, press “Select” again to edit.