Insert the two meter probes into the socket of the Amphenol Plug. The meter should read close to 29V DC. If you see 29V DC, the Amphenolotor Plug is good and you can go to Test 5A to check the Dolphin Motor.
Also question is, how do I turn on my Maytronics pool cleaner?
TURN POWER ON – Press the ON/OFF switch on the Power Supply. The Cleaner will start to operate. Note: Four LEDs will light up in the corners of the switch indicating that the power is on.
Simply so, how long is a dolphin Pool Cleaner cycle?
Each cleaning cycle is 2 hours. If it doesn’t finish cleaning in one cycle, you’ll have to manually restart it. All of that is done with a few buttons on the power supply. Like other cleaning robots with smart navigation, it will take a few cycles for it to map out the most efficient path for your pool.
How often should I run my dolphin Pool Cleaner?
I have owned a Dolphin Nautilus for about 4 years now. It cleans like a champ. My usual routine is to wait until the bottom of the pool is noticeably dirty before I run the robot. Generally, this may be once a week if the wind is not blowing too many leaves into the pool, twice a week if it is.
How do you test a Maytronics power supply?
Testing the power supply
- Connect the tester to the power supply.
- Switch the power supply on.
- If the tester light is on, proceed to test the cable.
- If the tester light is off, check the power socket and AC cable. If they are working, then replace the power supply and proceed to test the cable.
Why is there no suction in my pool vacuum?
Rule out the obvious causes of poor vacuum first. Make sure the water level in the pool is sufficient and air is not being sucked in through skimmer inlets. Add water to the pool to submerge the skimmers if necessary. Verify that the pump strainer basket and the skimmers are free of debris that may obstruct water flow.
Why does my pool cleaner get stuck?
If the suction is too strong, pushing the cleaner with a long pole virtually guarantees it will get stuck. Pulling the cleaner with a long pole isn’t as problematic, but it is still challenging. You just don’t have the control you have with a short pole.
How do I test dolphin cable?
Grip the cable firmly and pull it out of the socket. 4. Using a multimeter set to continuity, check the continuity of each wire. If continuity is good, replace the plug, it can only go in one way, and tighten the hold down nut.
Can you use an extension cord with dolphin Pool Cleaner?
Amazon.com: Customer Questions & Answers. Dolphin Nautilus Automatic Robotic Pool Cleaner with Dual Filter Cartridges, Two Scrubbing Brushes… Dolphin does not recommend an extension cord.
Why is my robotic pool cleaner not moving?
If your robotic pool cleaner stops moving, check the power cord. It may not be plugged in properly or there may be a problem with the power supply. Check the power supply to make sure the indicator light is on. If it is and the pool cleaner is still not moving, then the problem lies with the cleaner.
Why is my dolphin pool cleaner floating?
ADMIN REPLY: The bag may be retaining air. Try turning the robot upside down in the water and see if air escapes.
Can I leave my dolphin pool cleaner in the pool overnight?
While the unit can remain in the pool during use of the weekly timer function (if available on your model), we do not recommend leaving the cleaner in the pool for long extended periods of time.
Why does the creepy stop working?
The filter sand gets clogged
The most common cause for a Kreepy to stop working is clogged filter sand. This is easy to diagnose because whenever you backwash the pool filter, you’ll find that the Kreepy works like a bomb for 10 minutes. Then it gets sluggish and slows down or stops again.