How long is the cleaning cycle on a Dolphin pool cleaner?

or 2 hours

	S 300
Ideal pool length	Up to 12 m
Cleaning coverage	Floor, Walls & Waterline
Brushing	Brush + Active Scrubber
Cleaning cycle time	1 or 2 hours

>> Click to read more <<

Also know, how often should you run Dolphin?

If you have a lot of swimming in your pool, you can use the robotic pool cleaner every other day or once a day. If you don’t swim a lot, you should only run the pool once every two weeks.

Subsequently, can you leave pool vacuum in pool overnight? Cleaners aren’t meant to stay in the pool 24/7. This is true for all cleaners. Pressure side cleaners run on a schedule every day so why take it out? Leaving the cleaner in the pool 24/7 increases its exposure to corrosive chemicals in the water, such as chlorine or shock.

Regarding this, why does my Dolphin pool cleaner do wheelies?

What causes automatic pool cleaners to flip or do wheelies? The water level in a pool is one of the most common causes for this problem. When the water level is too high, the water line is very close to the coping. So when the cleaner starts to climb the wall, it hits the coping and flips on to its back.

How do I use Dolphin cleaner?

Just drop it in your pool, turn it on and leave it for about 5 hours. It computes a path to maximize cleaning and even climbs the walls to scrub and vacuum the entire pool floor, walls and waterline.

Why can’t you use an extension cord with a Dolphin Pool Cleaner?

Do not use an extension cord. In a wet deck environment the risk of stray voltage while small is signicant.

Can you leave the Dolphin cleaner in the pool?

Can you leave the Dolphin in the water? It is safe to leave your Dolphin cleaner in the water when not in use. However, (when adding chemicals to the pool) please remove the Dolphin until the proper chlorine and PH balance are obtained.

How do I know when my dolphin pool cleaner is finished?

SHUT DOWN – After about 3 hours of operation, the Cleaner will shut down automatically as indicated by the 4 LEDs turning off. The Cleaner can remain in the pool until you are ready to pull it out. Many people run the cleaner at night and take it out in the morning.

How do I setup my Dolphin pool cleaner?

Adjusting the handle angle

Lay the handle down at an angle of 180º to the ground.
Push the base of the arm into the body of the robot pool cleaner and slide it towards the rear of the robot pool cleaner until it clicks into the required position.

Can I use an extension cord with my Dolphin Pool Cleaner?

Dolphin Nautilus Automatic Robotic Pool Cleaner with Dual Filter Cartridges, Two Scrubbing Brushes… Dolphin does not recommend an extension cord.