This is a system that is well worth the price. I love the fact I can control everything by using my iPhone: my lights, my pump, my heater, etc. There are separate screens for your pool and spa.
Beside this, how do I upgrade my Hayward OmniLogic?
You need to bring the USB memory stick to the OmniLogic and simply plug it into the side of the Local Display behind the Dead Front. Next, you will go into OmniLogic’s Configuration Menu and push Firmware Upgrade. The OmniLogic will automatically reboot with the new Firmware.
People also ask, how much does it cost to install a pool automation system?
Pool automation systems can be less expensive than many other pool features and accessories. A pool automation system can cost anywhere from $1,800 to $4,000.
How do you unlock the configuration menu on a Hayward pump?
Press the ‘Menu’ until, ‘Configuration Menu-Locked’ appears. To unlock, press and hold the (<) & (>) until the text, on the display, changes from ‘Locked’ to ‘Unlocked’ (unit will beep).
How much does Hayward OmniLogic cost?
How Much Does it Cost? Hayward OmniLogic installations can start at $2,800.00 and run upwards of $4,500.00 depending on added accessories. If you’re worried about cost, don’t be.
How does sense and dispense work?
With the Sense and Dispense technology, CO2 or acid is dispensed into the filter system’s return water as needed until the pH probe reports proper pH level. CAUTION: IF YOU CHOOSE AN ACID FEEDER FOR pH CONTROL, additional safety precautions are required to ensure that an equipment malfunction is detected.
Where is USB port on Hayward OmniLogic?
You will need to bring the USB memory stick to the Omni Control product. For OmniLogic simply plug it into the side of the Local Display behind the Dead Front and for OmniHub you will need to access the port on the bottom of the display.
How do I connect to OmniLogic WIFI?
How do I calibrate my OmniLogic touch screen?
A series of five boxes will appear, touch the center of each box to calibrate the screen. Locate and tap on “RemoveDDT” AND power cycle the OmniLogic. On the right of the dashboard locate and tap the “config” icon. The DDT (device discovery table) holds a list of all the smart devices the MSP talks to.
How do I automate my pool?
Where is the USB port on Omni controller?
You will need to bring the USB memory stick with you to the Omni Control product. For OmniLogic, you will need to plug it into the side of the Local Display behind the Dead Front, and for OmniHub, you will need to access the port on the bottom of the display.