The Baquacil CDX System is chlorine-free and specially formulated to maintain a consistent oxidizer residual in pool water. The oxidizer residual in pool water plays a significant role in removing contaminants that put a strain on the pool thus keeping the pool clear all season long.
Considering this, what does oxidizer do for your pool?
Oxidizers are primarily used in swimming pools to shock or even super-chlorinate the water to destroy organic contaminates and kill bacteria. Any of these contaminates enter the pool from bathers and the outside elements.
Besides, why is my pool water cloudy with Baquacil?
Hazy or cloudy water indicates a water clarity problem in a pool. Haze results from accumulation of unwanted contaminant’s such as dirt, suntan lotion, bacteria and algae, body oils, and minerals. Haze also can be caused by improper water balance or problems with your circulation system.
How do I raise the pH in my Baquacil pool?
Directions
- Test your water’s pH every week with Baquacil Test Strips and adjust if necessary. Generally, 1/2 lb of Baquacil pH Increaser in 10,000 gallons of pool water will raise pH by 0.2. …
- Allow the water to circulat for 12 to 24 hours. Recheck your pH reading.
How long do you have to wait to swim after putting in Baquacil?
How do I shock my pool with Baquacil?
Circulate the pool water. Follow with a treatment of Baquacil Oxidizer (Shock) about 1 hour later and continue to run the filter overnight. The pool water should be looking much better at this point.
How long does Baquacil last?
How do you close a Baquacil pool for the winter?
Closing Your Above Ground Pool with Baquacil
- Balance your pool’s water chemistry prior to closing the pool. …
- Clean your pool thoroughly. …
- Lower the water level approximately 6” below the wall skimmer and use a return plug in the return outlet. …
- Drain water from your skimmer, remove basket and replace the top.
What are the 3 steps to Baquacil?
The BAQUACIL® CDX™ System includes three key components that work together to save you time and maintenance: BAQUACIL® Sanitizer and Algistat (step 1), BAQUACIL® Oxidizer (step 2) and BAQUACIL® CDX® (step 3).
How do I treat my Baquacil pool?
a. Add 1 gallon of BAQUACIL Oxidizer for every 10,000 gallons of pool water. Allow the water to circulate for 8-12 continuous hours. Verify that the free chlorine level is 0, by using a “DPD”-type testing kit with a DPD #1 tablet.