Priming Failure
If the pump is not defined as primed within the “Max Priming Duration” it will stop and generate a “Priming Alarm” for 10 minutes, then attempt to prime again.
Beside above, how do you bleed a Pentair pool pump?
In this way, how long does it take to prime a pool pump?
Allow water to run into the pump housing for at least two minutes. This will allow some water to seep into the pipes that extend from the skimmer to the pump so there’ll be enough water to create suction in the pump.
How do I program my Pentair Intelliflo VSF?
How do you prime a Pentair variable speed pump?
How To Prime Your Pentair Pool Pump
- Turn off power to pump (switch and breaker)
- Using black 3 way valve, turn off Skimmer (main drain on only)
- Remove pump lid.
- Fill pump with water all the way to top.
- Put pump lid back on.
- Turn on Pump.
How do I reset my Pentair Intelliflo VSF?
How do I reset the schedule on my Pentair Intelliflo pump?
Why does my Intelliflo pump keep shutting off?
It could be a bad drive, over voltage, under voltage, drive over heating, ect. You could eliminate it being a control problem by unplugging the control cable on the motor, and manually running it. If it does not do it anymore then it is a control issue.
Why does my pool pump not prime?
How do you prime a variable speed pool pump?
Steps to Prime Your Pool Pump
- Turn off the pump. …
- Switch to recirculate. …
- Release air. …
- Clean out the pump basket. …
- Fill the pump basket. …
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.
How do I reset Intelliflo pump?
To reset the pump to the factory default settings:
- Ensure that the pump is powered on and the green power LED is on.
- Press the Stop button to stop the pump.
- Press and hold all of the four Speed buttons simultaneously for four seconds. Power off the drive.