The AquaTrol has all the same functions and features of the Aqua Rite but with a lower chlorine output. The AquaTrol also has an integral time clock for control of the pool filtration pump.
Also to know is, how do I reset my aqua rite?
Moreover, what does inspect cell mean on salt water pool?
If both the “check salt” and the “inspect cell” lights stay on, it most likely means that no chlorine is being produced at this time and your salt level fell below 2300 ppm. Both lights will also stay on if the controller is set to the wrong turbo cell type, or if the cell is unplugged.
How do I reset my Hayward Aqua Rite salt chlorine generator?
Reset AquaRite Salt Chlorination Inspect Cell Light
If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How do you troubleshoot a Hayward salt Cell?
To manually reset the Inspect Cell LED, press and hold the Diagnostics button until the LED turns off (about 3-5 seconds).
- Verify that the salt level is between 2700 – 3400 ppm. 3200 ppm is the ideal salt level.
- Inspect and clean salt cell, if necessary.
- Check the cell voltage and amperage in both polarities.
How do I reset my Aqua Rite 900?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How do I know if my salt chlorinator is working?
The easiest way to ascertain if the chlorinator is working is to make sure the cell is clean by checking the needle or production lights. Ensure there is enough salt in the pool. On the chlorinator box there should be a light or dial that indicates it is working.
How do you calibrate a Hayward Aqua Trol?
Turn Salt System Off and On
With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process.
How do you read Hayward Aqua Trol?
What is Aqua Trol?
AquaTrol is the affordable salt chlorine generating solution for above ground pools that saves you time and money while conveniently keeping your pool clean and safe. NEW firmware version (Oct. 2019) allows users to toggle between Low Salt Mode (approx. 1,500 PPM) and Normal Salt Mode (approx. 3,200 PPM)
What should my chlorinator read?
On a Hayward Salt Chlorinator, your salt reading should be between 2,700 – 3,400 PPM (parts per million) with the optimum level of 3,200 PPM.