The lever should be on the ‘Filter’ setting most of the time. This is the setting that provides normal pool filtration by pushing the water through the filter media (sand, glass beads or D.E) that then traps any dirt and debris before the water is returned to the pool.
Additionally, how do you bleed air out of a sand filter?
Furthermore, how do I get air out of my pool pump?
How do I use my Hayward pool pump?
How to Operate a Hayward Pool Pump
- Ensure the hoses are securely attached. …
- Check the skimmer water level. …
- Add water to the pump basket. …
- Open the air valve. …
- Confirm that the necessary cleaning agent is in the filter. …
- Monitor the filter’s pressure gauge and water return flow.
How do you prime a Hayward sand filter?
What setting do you use to vacuum a pool with a sand filter?
To begin vacuuming your pool:
- If you have a sand filter and are vacuuming to waste, set filter to “waste” option. …
- Otherwise, leave setting on “filter” and turn pump on to begin vacuuming. …
- Vacuum your pool just as you would vacuum your living room, picking up debris or algae as you go.
What pressure should sand filter for pool be at?
The pool filter pressure should be steady, operating in a range of +/- 10 psi. When it’s outside this range, very low or very high, then you know that something’s wrong. Some gauges allow you to set the clean and dirty range, or you can write it on the filter tank with a marker.
How do you adjust a Hayward pool pump?
Are Hayward pool pumps self-priming?
Hayward in-ground pumps are self-priming centrifugal pumps. These pumps have a vacuum chamber, commonly known as a pump housing. The pump housing must be filled with water in order to create a vacuum, resulting in the pump drawing the water out of your pool or spa.