Rinse runs water in the same direction that normal filtering does. Backwash runs it through the sand in the opposite direction. Rinse is to clear any dirt out of the clean side of the sand before you start sending it back to the pool.
Similarly one may ask, what does Rinse do on Hayward pool filter?
The ‘Rinse’ setting should be used after backwashing and again run just for a minute or two. On this setting the water is flowing through the filter in the normal direction but once again is being sent to the waste pipe rather than being returned to the pool.
Beside this, at what PSI should I backwash?
As a general rule, you should be backwashing your pool about once a week or in conjugation with your scheduled maintenance. Another industry standard is to backwash when your filter’s pressure gauge reads 8-10 PSI (pounds per square inch) over the starting level or “clean” pressure.
How long do you rinse after backwash?
Turn the lever to RINSE, start the pump and rinse for about 15-30 seconds. Stop the pump and turn the lever to FILTER. This is the normal operating position. Close the drain outlet valve and start the pump.
Can you backwash too much?
Can You Backwash Too Much? If you backwash your pool too much i.e. time duration and/or close frequency then yes you can cause a lot of problems. Some problems that can arise from backwashing your sand pool filter too much are: Loss of water – 500+ litres of water can be lost in each backwashing cycle.
What is the rinse function on a sand filter?
In a sand filter, the rinse cycle allows water to flow back down through the sand to flush out any remaining dirt and debris from the filter and piping. The rinse cycle also restratifies (deposits in layers) the sand, letting it resettle in the filter tank.
Is rinse the same as waste?
Rinse: This cleans the water filled inside the filter tank. Circulate/Bypass/Recirculate: This setting is used when you need to return the water back into the pool without making it go through the filter. Drain/Waste: Opting the drain or waste setting will remove pool water without forcing it through the filter.
Do you vacuum a pool on backwash or waste?
If you do have this option, it is highly recommended that whenever you have algae, you will need to vacuum to waste. This option allows you to vacuum the algae up and send it out through the backwash line, avoiding getting algae into your filter sand.
What is the waste setting on my pool filter?
WASTE/DRAIN: Another filter bypass setting, but this setting sends the water out of the waste pipe (hose), instead of returning it to the pool. This setting is used to lower pool water level or to vacuum to waste, which is best when vacuuming algae or heavy amounts of dusty, silty debris.
How do you backwash and rinse?
Does backwashing remove water from pool?
The backwashing process reverses the flow of water to flush out contaminants from a swimming pool filter. It should be carried out until water runs clear through the waste line.
Should you rinse after backwash?
In order to ensure against residual blowback into the pool, once you’ve finished backwashing it is highly advisable to rinse the filter. Just as the backwash lifts and flushes the sand, the rinse reseats the sand in its original position for optimum filtration.