Your pool cleaner is floating because there’s air in the hose caused by a loose coupling, a hose crack, or a worn O-ring. Remove the pool vacuum and inspect the hose for cracks and leaks, then check the couplings to ensure they’re snug. Replace leaky sections and it won’t float anymore.
In this way, can I use an extension cord with my Dolphin pool cleaner?
Dolphin Nautilus Automatic Robotic Pool Cleaner with Dual Filter Cartridges, Two Scrubbing Brushes… Dolphin does not recommend an extension cord.
Beside above, why is my pool robot not working?
If your robotic pool cleaner stops moving, check the power cord. It may not be plugged in properly or there may be a problem with the power supply. Check the power supply to make sure the indicator light is on. If it is and the pool cleaner is still not moving, then the problem lies with the cleaner.
Why does my pool cleaner keep falling over?
Cleaner keeps falling on its side.
Check to make ensure that the hose connected to the head is the leader hose (the section of hose with the grey cuff). A connector hose attached at this point can cause this situation. Check to make sure the leader hose is in good condition. Hold the leader hose by one end.
Why is my Dolphin pool cleaner doing wheelies?
What causes automatic pool cleaners to flip or do wheelies? The water level in a pool is one of the most common causes for this problem. When the water level is too high, the water line is very close to the coping. So when the cleaner starts to climb the wall, it hits the coping and flips on to its back.
How do I know when my Dolphin pool cleaner is finished?
SHUT DOWN – After about 3 hours of operation, the Cleaner will shut down automatically as indicated by the 4 LEDs turning off. The Cleaner can remain in the pool until you are ready to pull it out. Many people run the cleaner at night and take it out in the morning.
How do you adjust the float on a Polaris 280?
Moving the float completely forward, toward the feed pipe, will increase the climbing ability. For the location of the head float, see the “Assembling the Polaris” diagram. The sweep hose should move in a gentle sweeping motion. To decrease its motion, turn the sweep hose adjustment screw clockwise.
How often should I run my Dolphin pool cleaner?
Ideally, you need to run your robot pool cleaner daily or at least once a day if you’re always swimming in it. But if you don’t swim in it as much, run it at least once weekly or every two weeks. When you’re using a swimming pool cover all the time, you may wash your pool monthly.
Should pool vacuum hose float?
Cleaner floats above the pool floor.
The cleaner is heavier than water, and should not float.
Can I leave my Dolphin pool cleaner in the pool?
This will help protect the Dolphin from surges in power such as thunderstorms. Can you leave the Dolphin in the water? It is safe to leave your Dolphin cleaner in the water when not in use. However, (when adding chemicals to the pool) please remove the Dolphin until the proper chlorine and PH balance are obtained.