Why is my pool robot not picking up dirt?

POOL CLEANER IS NOT CLEANING

If your pool cleaner is moving around the pool normally but is not picking up debris, the normal solution is to clear the clog in the suction throat, or empty the debris bag or basket. Suction cleaners also need a clean pool filter to both move and vacuum well.

>> Click to read more <<

Keeping this in view, where is the impeller on my dolphin?

Likewise, why is my robotic pool cleaner not moving? If your robotic pool cleaner stops moving, check the power cord. It may not be plugged in properly or there may be a problem with the power supply. Check the power supply to make sure the indicator light is on. If it is and the pool cleaner is still not moving, then the problem lies with the cleaner.

Also to know is, can Maytronics power supply get wet?

The power supply is water resistant but not waterproof. Please cover the power supply if inclement weather approaches. Do not leave the power supply in standing water as this will damage the internal components.

Why does my dolphin pool cleaner keep doing wheelies?

What causes automatic pool cleaners to flip or do wheelies? The water level in a pool is one of the most common causes for this problem. When the water level is too high, the water line is very close to the coping. So when the cleaner starts to climb the wall, it hits the coping and flips on to its back.

How do you reset a Dolphin pool cleaner?

Turn the power supply OFF. Wait 30 seconds, then turn it back on. Pool Cleaner does not move / Red light on the power supply.

Why won’t my Dolphin pool cleaner climb walls?

My Dolphin Won’t Climb Walls / Gets Stuck

Clean filters: The Dolphin’s filters may be clogged and need to be cleaned. Make sure you clean these filters after each use. Do not allow filters to dry out before cleaning. Deeper cleaning of the filters is also highly encouraged and may be required occasionally.

How long is Maytronics warranty?

for 3 years

How do I get my Dolphin pool cleaner to work?

The Maytronics Dolphin Nautilus Robotic Cleaner is self-contained and fully automatic. Just drop it in your pool, turn it on and leave it for about 3 hours.

Why is my pool not suctioning?

It could be something blocking it, a dirty pool filter, or too much air in the system. If there’s something blocking your pump’s suction, check your filter gauge. If it’s 10psi above the normal reading, clean your filter. This will reduce pressure and reset your pump’s flow.

How do I increase the suction on my pool vacuum?

Why is my pool robot not climbing the walls?

The most common reason robotic pool cleaners suddenly stop climbing your pool wall is because the surface becomes slippery due to algae build up.

Leave a Comment