Suction cleaners typically run at around 2200-2400 RPM. Heaters require 20 to 40 Gallons Per Minute (GPM) so might run at around half speed or a little higher. You would probably want to run your Spa at up to full speed, 3450, for maximum effect.
Moreover, how long should I run my Pentair Intelliflo pump?
The rule of thumb is generally 8 hours, although it could be anywhere from 6-12 hours, depending on your pool’s size. Each pool is unique, so to keep your pool pump efficient and effective, you need to figure out exactly what your pool’s turnover rate is.
Accordingly, what is the recirculation setting on a sand filter?
The Recirculate setting allows water to move through the filter without going through the filter media. Note: You can also use the Waste setting for this if you’d rather completely remove the dirty water rather than recirculate it back into the pool.
What are the best hours to run your pool pump?
The best time to run your pool pump is during the warmest hour of the day; however, keep in mind that this means you will have higher energy consumption, which may lead to an increase in your electric bill. If you want to save on your energy costs, you can run your pool pump at night to avoid peak hours.
How do you program a Pentair?
Is it better to run pool pump at night?
It’s best to run your pool pump during the day
Not only does sunlight give fuel for algae to grow, it also destroys your pool chlorine and this is why you should always run your pool during the day!
What should my pool pump be set on?
The lever should be on the ‘Filter’ setting most of the time. This is the setting that provides normal pool filtration by pushing the water through the filter media (sand, glass beads or D.E) that then traps any dirt and debris before the water is returned to the pool.
Should I run my variable speed pool pump all the time?
However, it is important to note that a variable speed pool pump should ideally be running 24 hours a day to ensure proper and optimal water circulation. When your pool pump is not running, the water is sitting stagnant in your pool allowing bacteria to survive and grow.
Is it OK to run pool pump 24 hours a day?
The size of your pool, the efficiency of your pump and filter, and how dirty your pool is are just some of the factors you need to consider. Nevertheless, most pool cleaning professionals would advise against running a pool pump for more than 8 hours a day.
Should I run my pool pump in freezing weather?
Run your pool pump continuously when temperatures are near or below freezing. You don’t need to run your heater, moving water likely will not freeze. Disconnect any aerators and lines to slides. Booster pumps for pool cleaners don’t need to run continuously.
How many hours should I run my pool pump in the winter?
What should a variable pool pump be set at?
Example of Variable Speed Settings
Generally, I run my equipment at 1700 RPMs for 10 hours. I run this with the saltwater generator set at 50% for 10 hours. In my case, 1700 RPM’s is the minimum I can do to reliably activate the saltwater generator and filter the pool.
How long and at what speed should I run my variable speed pool pump?
Should pool pump run all the time?
Although it’s generally recommended that all the pool water undergo filtration every 24 hours, the pump does not need to run all the time. A proactive, productive and energy-saving maintenance activity is to remove the debris floating on the pool surface with a hand-held skimmer.
How should I program my variable speed pool pump?
Can I run my pool pump every other day?
You can run your pump at any time of the day but if you want to save money, its smart to run it during non-peak hours. During peak hours electricity companies charge consumers a higher rate due to increased demand.
Does pool heat faster with pump on high?
Heat transfer efficiency is higher with higher flow rates. However, you have to look at total efficiency and cost. It may be worth the extra heat loss to run the pump at lower speeds.